The manufacturer of the operation stand tells the precautions for welding the operation stand

1. The operator of the machine must be familiar with the structure, working principle and operation method of the equipment.

2. The operator of the machine is not allowed to wear gloves for operation. The long hair of the female worker should be coiled up. It is not allowed to wear too loose clothes. It is not allowed to contact the belt, transmission part, blade, etc. to prevent personal injury.

3. Before starting the machine, check whether there are tools or other sundries on the paper feeding table. Press the electric bell first when starting the machine, and then start the machine after receiving the response from other operators of the machine. If you do not start the machine after pressing the electric bell, press the electric bell again after a period of time, and then start the machine after confirming the safety. Do not start the machine directly at high speed. Start from zero speed and gradually pass the speed Degree knob reaches rated working speed.

4. The slotting part shall be operated according to the procedure. The cutting edges of the slotting knife and the paper separator are very sharp and easy to hurt hands. The upper slotting knife must fall into the lower slotting, and the fastening screws must be locked after the knife is adjusted at the position and the central position, and attention shall be paid to put the paper shoveling knife into the paper shoveling slot. After the linkage adjustment of the four knives, remember to lock the fastening screws. After each part is adjusted and locked, first turn the slotting part with the handle If there is no abnormal phenomenon, you can continue to operate the equipment at high speed. If you don't leave your hand behind, you will encounter a sharp knife edge. Especially, you should be careful that in production, if you violate the operation regulations, you will easily cause injury accidents.